Fass FA D09 095G Bedienungsanleitung

INSTALLATION MANUALAPPLICATION:FA D09 095G (95gph @ 15psi)Cummins 5.9L 12 ValvePumping into mechanical Lift Pump1994-1998

B. Secure THB-1001 to bolt on bracket with the RS 1002 and the (2)– 1/4-20x1 bolts, 1/4 washers, and 1/4 nuts. With the (4)-1/4-20x1.75” bolts thr

D. Slid the FASS pump into mounting brackets with the weep hole facing down. Torque (4) bolts to 110 inch pounds. VERY IMPORTANT: REMEMBERING THE

A. Using a 3/8” hose clamp install the QD-1001 into the fuel line. Oil o-rings inside Quick Disconnect. B. Disconnect factory suction line clip by

 Blow out any open lines/cover any open ports  Bolts and fasteners properly tightened?  Electrical harness and fuel lines secured and properly

Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep

Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of

FASS Recommended Application FA D09 095G Cummins (12 Valve) 1994-1998 with stock - moderate horsepower modifications pumping to the factory mech

(FA D09 095G) (FA D09 095G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS ADJUSTAB

Installation Step 1: Install Electrical Harness Step 2: Mount Fuel System Step 3: Install Fuel Line Step 4: Check/Set Pressure Step 5: Che

Contents FL-1002 x14’ WH-1001 BHB-1001 THB-1001 FF-3248 MP-9006 FPB-2005

10-300 PL-1005 10-299 Ring Terminal HC-1001 QD-1001 RS-1002 Mounting Package Contents *Cable Ties* 46044 46260 4 1/4 - 20x1.75” 1/4” Nut 1/4”

C. Using the ring terminal, connect green wire to a clean ground or nega-tive battery terminal. D. Secure relay and fuse in an upright pos

G. Route wire harness along frame to the mounting location of the FASS pump. Completion of this step will be addressed in the Mounting Step. F. Lo