INSTALLATION MANUALAPPLICATION:FA C09 220G (220gph @ 10psi)Duramax 2500 & 35002001-2015
E. Remove filler neck tube and over-flow tube from the top of the fuel tank by loosening clamp. Some models have an integrated filler neck.
G. Check fuel tank for good installation location of the suction tube assembly. Remove the lock ring on top. Mark location of Fuel Module in relation
K. With proper length being obtained with the suction tube, de-bur and flush assembly. Slide tube through hole, lock washer, and nut. Make sure O-ri
Note: Use of Anti-seize compound is highly recommended. B. Secure THB-1001 to bolt on bracket with the RS 1002 and the (2)– 1/4-20x1 bolts, 1/4 wa
D. Slid the FASS pump into mounting brackets with the weep hole facing down. Torque (4) bolts to 110 inch pounds. VERY IMPORTANT: REMEMBERING THE
A. Route suction line from Step 2L to port ‘T’. Cut FL-1002 to needed length. Using oil, insert PL-1005 and connect to 10-300 in port ’T’. Torque
F. Carefully re-bend sheet metal back to original shape to protect fuel tank, if needed. G. Re-install driveshaft Note: Secure all fuel li
Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep
3 Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of
FASS Recommended Application FA C09 220G Duramax 2001-2014 with super extreme horsepower modifications ¡WARNINGS! Read all instructions before s
(FA C09 220G) (FA C09 220G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS ADJUSTABL
220 GPH 10 PSI (Approximately) Adjustable Fuel Pump Series A fuel pressure gauge is highly recommended to identify fuel filter life and to prevent
Contents FL-1002 x14’ WH-1006 MP-9038 BHB-1001 THB-1001 FF-3248 FPB-2005
HC-1001 PL-1005 Ring Terminal BHF-1002 PL-1004 ST-1005Px16” BHN-1001 OR-223 LW-1001 QD-1002 RS-1002 *Cable Ties* 10-300 1/2” Plug Mounting Package
C. Crimp the ring terminals to the red and green wires of the WH-1006 Wire Harness. Attach red wire to the positive terminal of the battery an
E. If fuse panel is located in the cab it will be necessary to guide the single red wire from the relay through the fire wall grommet to access t
Kommentare zu diesen Handbüchern