INSTALLATION MANUALAPPLICATION:T C10 220G (220gph @ 8psi)T C10 260G (260gph @ 8psi)Duramax 2500 & 35002001-2014**Note: Cab and Chassis may require
B. Remove the 3 bolts holding the fuel cooler to the mounting bracket. The fuel cooler is located in front of the fuel tank. C. Using a fuel line d
E. Disconnect electrical harness. Using disconnect tools, remove factory suction & return lines from fuel module. Pinch in tabs on 2011. Disconne
J. Place the suction tube assembly into hole. Take measurements so the bottom of the suction tube is only 1/8” (no more than 2 quarters s
A. Using thread tape, install the 10-300 into “E” and the 10-302 into the “T” port (on opposite end). Torque to 40 lb./ft.² Note: D
F. Position the PBR-2001 to the PFB-2002 pump assembly at the mounting location and check for fit. Once location is established mark locati
H. Once secure use (3)1 1/2 bolts and (3) WA-1001D spacers to mount the pump to the bracket. G. Assemble the FASS pump bracket PBR-2001 using the R
I. Apply motor oil to gasket located on filters. Attach to system and hand tighten. Fuel Filter –Install FWS-3003 on side of pump with draw
C. Insert PL-1005 in remaining fuel line using oil. Connect to the ‘E’’ port of the FASS system. Torque to 18 ft./lbs. Route this fuel line to the fa
Note: The Red Plastic Plugs located in the “H” ports can stay in place fuel will not flow through these ports. Coolant can be plumbed into these port
Blow out any open lines/cover any open ports Bolts and fasteners properly tightened? Electrical harness and fuel lines secured and properly t
Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of t
Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network repre
FASS Recommended Application T C09 220G Duramax 2001-2005 with super extreme horse power modifications Serial # ¡WARNINGs! Read all instructions
(T C10 220G or T C10 260G) (T C10 220G or T C10 260G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new
Titanium Series Installation Step 1: Install Electrical Harness Step 2: Prepare Suction and Return Lines Step 3: Mount Fuel System Step 4: I
Contents PBR-2001 PFB-2002 FL-1002 x 9’ WH-1006 MP-9046 FL-1058 x3’
PL-1005 Mounting Package Contents HC-1001 QD-1002 BHN-1001 BHF-1002 ST-1005Px16” LW-1001 10-300 PL-1004 OR-223 Ring Terminal *Cable Ties* 4 Hex Bo
The installation of the electrical harness is done first, allowing power to be applied to the pump for lubrication purposes later in the installation.
E. If fuse panel is located in the cab it will be necessary to guide the single red wire from the relay through the fire wall grommet to access the
Kommentare zu diesen Handbüchern